REVO PC series

  • load type: resistive or long-, medium- and short wave infrared (IR) lamps
  • maximum load current: depending on the connected REVO Sx (3.5-90A) or REVO S (30-800A)
  • maximum load voltage: depending on the connected REVO Sx (240Vac/480Vac) or REVO S (480Vac, 600Vac or 690Vac)
  • power control input:
    • logic input on/off SSR signal (4-30Vdc)
    • read by REVO PC from temperature controllers or PLC/DCS system over fieldbus communication interface
  • power control outputs: 24x logic output on/off SSR signals to control either REVO Sx or REVO S units 
  • firing modes:
    • single cycle at 50% power demand
    • half cycle at 50% power demand (not for 4-8 channel RPC 204-208 2 phase control of star/delta)
  • control modes:
    • open loop
    • power (VxI)
  • MODBUS RTU RS-485 and MODBUS TCP ethernet interface
  • fuses: inside REVO Sx or REVO S units
  • heater break alarm
  • thyristor short circuit alarm
  • Optional
    • ProfiNET and MODBUS TCP interface
    • ProfiBUS and MODBUS TCP interface
    • Ethernet/IP and MODBUS TCP interface
    • REVO KPC SCADA/HMI screen. Up to 24 slaves can be connected

 REVO PC series catalog
– REVO PC  serial communication manual

Click here to request a quotation for the REVO PC.

12-24 channel 1 phase independent channels shared on the 3 phases, connection phase to phase
12-24 channel 1 phase channel balanced on the 3 phases, connection phase to neutral
8 channel star without neutral or closed delta connection
8 channel star with neutral connection
REVO Sx multichannel 1 phase units